Aeon Labs Micro Smart Energy Illuminator Service Manual download pdf (Page 3)

Configuration Parameters

Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better

to user needs or unlock further enhanced features.

IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 … 255 the value sent in

the application shall be the desired value minus 256. For example: to set a parameter to 200 it may be needed to set a value of

200 minus 256 = minus 56. In case of a two byte value the same logic applies: Values greater than 32768 may needed to be given

as negative values too.

Type of Sensor Report (Parameter Number 1, Parameter Size 1) Defines the value type to be sent as Sensor

Report.

Value Description

0 Power (Default)

1 Voltage

Blinking Behavior (Parameter Number 2, Parameter Size 2) This is a double byte value. The LSB defines the total

time the device need to blink. The value if set in seconds. The MSB defines the on/off interval of the blinking. The unit is 0.1 s.

Value Description

0 — 65535 Configuration Bytes (Default 0)

Notification on Status Change (Parameter Number 80, Parameter Size 1) Defines the automated status

notification of an associated device when status changes

Value Description

0 Deactivated (Default)

1 Hail sent

2 BASIC Report Sent

Disables Function of automated sending of a Report triggered by minimal change of value.

(Parameter Number 90, Parameter Size 1)

Value Description

0 Disabled (Default)

1 Enabled

Minimum Change to send Report (Watt) (Parameter Number 91, Parameter Size 2) The value represents

the minimum change in Wattage for a Report to be sent .

Value Description

0 — 32000 W (Default 50)

Minimum Change to send Report (%) (Parameter Number 92, Parameter Size 1) The value represents the

minimum change in Watage Percent for a report to be sent

Value Description

1 2 3 4 5

No comments

Aeon Labs Micro Smart Energy Illuminator Service Manual Page 3